"Stop stripping threads on quickbolts:"

Stick an all-thread rod coupling of various sizes (1/4 x 20, 3/8", 1/2", etc.) in your tool box. Use those to set quickbolts (stud anchors) instead of using the nut supplied with the anchor.
It works great. That way you don't destroy the threads on the anchor (causing you to start all over again), and you can use this as a stop to be sure you leave the right number of threads showing.
Also, if you did not know this, always drill your hole deep on a quickbolt, because you can stop the set whenever you want even if the hole is too deep.



If you have any Tricks of the Trade you would like to add or if you have any comments please feel free to Email E.T.E..

Tricks of Trade

Back to Main Page

2007, Electricians Toolbox Etc...

Design by TC