"Easy Way To Set Nail-In Anchors:"

From:  Eric Aubry aubseric@netscape.net

If your hammerdrilling holes for nail-in anchors, bandsaw cut an old or broken drill shaft off, swap with good bit in drill a hammer away.(I found using a 5/8" SDS about 2" long to work best after boring a small dimple in the center of the cut end).


If you have any Tricks of the Trade you would like to add or if you have any comments please feel free to Email E.T.E..

Tricks of the trade
Back to Main Page

2007, Electricians Toolbox Etc...

Design by TC