"Use coat hanger to fish"

From: Kenneth <"kscron@execpc.com"@mail.execpc.com>


Take a wire coat hanger and cut off the bottom part. Cut one end at an angle. You now have a drill bit. Drill through the floor at hte edge of the carpet and just in front of the molding. Go to lower level and locate wire. Measure over about 1 3/4" for the center of wall and drillup. You should be right below your cut-in. This drill bit does not get caught on the threads of the carpet.

 


If you have any Tricks of the Trade you would like to add or if you have any comments please Email E.T.E.

Tricks of Trade

Back to Main Page

2007, Electricians' Toolbox Etc...

Design by TC