July 2000

Test your knowledge of the code, by taking E.T.E.'s code quiz.
There are 10 questions, which are multiple choice.
Based on the 1999 Code Book.

 

By: Robert Keis


Question #1:
Power for a legally required standby system shall be available _________.
(A) immediately
(B) within 10 seconds
(C) within 30 seconds
(D) within 60 seconds

Question #2:
Which of the following type motors would not be permitted in a Class II, Division 2 location?
(A) A motor listed for Class I locations
(B) An open-type polyphase motor with no overtemperature or resistance devices
(C) A totally enclosed non-ventilated motor
(D) A totally enclosed pipe-ventilated motor

Question #3:
Lighting systems operating at 30 volts or less shall be supplied from a maximum _______ ampere branch circuit.
(A) 15      
(B) 20
(C) 25
(D) 30

Question #4:
The floor of a vault shall have adequate structural strength for the load imposed thereon and a minimum fire resistance of ___ hours.
(A) 1.5
(B) 2
(C) 3
(D) 4

Question #5:
Pendant conductors for incandescent filament lamps shall not be smaller than No. ____ for intermediate or candelabra-base lampholders.
(A) 14
(B) 16
(C) 18
(D) 20

Question #6:
Transformers and electronic power supplies for electric signs shall have _________.
(A) secondary ground-fault protection
(B) ground-fault protection for personnel
(C) ground-fault protection for equipment
(D) any of the above

Question #7:
Cartridge fuses shall be plainly marked to show the interrupting rating when other than _______.
(A) 5,000 amperes
(B) 7,500 amperes
(C) 10,000 amperes
(D) 15,000 amperes

Question #8:
Two four foot sections of lighting track that are installed in a continuous row shall have a total of how many supports?
(A) 2
(B) 3
(C) 4
(D) 5

Question #9:
Wet locations of heath care facilities are designated by ________.
(A) the governing body of the facility
(B) the Board of Health
(C) the National Electrical Code
(D) the electrical inspector

Question #10:
Lightning down conductors for a lightning protection system are permitted to be routed in the elevator hoistway.
(A) True
(B) False


Thanks for taking E.T.E.'s Code quiz!

If you find any discrepancies please feel free to email E.T.E. at http://www.elec-toolbox.com/email.htm.

Back to ETE's Code Quiz Page

Back to Main Page

2000, Electricians' Toolbox Etc...

Design by TC