"Bending PVC without a bender:"

From: Jim Taber jtaber@netonecom.net

 

The best way I have found to bend PVC when you're cought without a bender is simply stick it in the tailpipe of your truck.  It only takes a few minutes at an idle to get the PVC warm enough to bend. Just be sure you have couplings, the bell end will disapear!
 

 


 

If you have any Tricks of the Trade you would like to add or if you have any comments please feel free to Email E.T.E..

Tricks of the trade
Back to Main Page

2007, Electricians Toolbox Etc...

Design by TC