"Bending PVC with truck exhaust::"

From: Brent A. Heller

Start truck and cut a piece of conduit to use as a wedge between gas pedal and seat. You want rpms to be between 1500-2000 rpms. Let truck warm up.
Then take the piece of pvc conduit you want to bend and tape the ends with duct tape. Place conduit at tail pipe of truck right  were the exhaust comes out. This heats up the conduit and then bend it. Works well even in the snow.


If you have any Tricks of the Trade you would like to add or if you have any comments please feel free to Email E.T.E..

Tricks of the trade
Back to Main Page

2007, Electricians Toolbox Etc...

Design by TC