"Use Pull String to Pull Wire:"

From: J. Carns

When making up a head for pulling wire, cut 3 pieces of 150lbs pulling string about 8 feet long. Take each piece and fold them in half and then tie the folded pieces on to your rope. Now you have 6 pieces 4 foot long. Now grab two strings and start braiding them down your wire and when your done brading  tie them off and grab 2 more, and then finally the last 2. This makes a really strong head that will not brake and it is a lot quicker than using the tye wire method and of lot more flexible.



If you have any Tricks of the Trade you would like to add or if you have any comments please feel free to Email E.T.E..

Tricks of the trade

Back to Main Page

2007, Electricians' Toolbox Etc...

Design by TC