"A different way to ream pipe:"

From: vortecs10@aol.com

In commercial work time is of the essence. When cutting EMT, reaming is not just code but standard. If on a small pipe run without a file to ream, cut your pipe and use the scrap piece to rub the inner and outer diameter of the good piece.Using circular back and forth motions ensures a smooth fitting for your connector or coupling. This can save time from walking back and forth to the van on a large jobsite.



If you have any Tricks of the Trade you would like to add or if you have any comments please feel free to Email E.T.E..

Tricks of the trade

Back to Main Page

2007, Electricians Toolbox Etc...

Design by TC